Samsung WAM351 User Manual page 14

Attach the HUB's power cord to the power port on the rear of the HUB, and then plug
2
the power cord into an electrical outlet.
The power ( ) and the HUB (
3
When the pairing indicator (
The pairing indicator on the M3 starts to flash.
If the HUB's pairing indicator does not flash, press the
HUB.
note
9 If you are adding multiple M3s, connect all the M3's to electrical outlets. If you are not connecting all
the M3s, refer to pages 32~38.
Wait until the pairing indicator on the M3 stops flashing. If the M3's LED indicator turns
4
solid blue, pairing is complete. The M3 may also beep.
notes
9 Place each M3 at least 20 inches (50 cm) from the HUB when connecting them to the HUB.
9 Your smart device cannot connect to the M3 or the HUB if there is no wireless router.
9 To confirm you have a proper connection, check the pairing indicator on the front of the HUB.
- When you turn on the HUB for the first time, there is a 20 minute pairing period.
The pairing indicator (
SPK ADD
the
indicator (
the pairing indicator is flashing.
- If pairing mode has expired, press the
mode again. Then, turn the M3 off and then on or press the
to link the M3 to the HUB.
9 For a proper connection, connect the HUB to your router before turning on the M3.
- Connecting the M3 to the HUB may take a few minutes.
- There will be a brief sound when the connection is established.
) indicators on the HUB's front turn on.
) begins to flash, plug the M3(s) into an outlet.
Press here
) will blink for these 20 minutes or until pairing occurs. When you press
button to pair additional M3s, the pairing period is reduced to 10 minutes. The pairing
) flashes for 10 minutes or until pairing occurs. Turn on the M3 you want to pair while
spK Add
SPK ADD
button on the rear of the HUB to turn on pairing
SPK ADD
4444 14
button on the rear of the
button on the rear of the M3