Table of Contents
Advertisement
fills with the wrong water
temperature.
load is wet at the end of a
cycle.
leaks water.
has odors.
no bubbles are seen
(bubbleshot models only).
Wi-fi does not work (Wi-fi
models only).
WF36J4000AW-02832L_EN.indd 31
•
Fully open both taps.
•
Make sure the temperature selection is correct.
•
Make sure the hoses are connected to the correct taps. Flush water lines.
•
Make sure your water heater is set to supply a minimum 120 °F (49 °C) hot
water at the tap. Also, check the water heater capacity and recovery rate.
•
Disconnect the hoses and clean the mesh filter. The mesh filter may be
clogged.
•
While the washing machine fills, the water temperature may change as the
automatic temperature control feature checks incoming water temperature.
This is normal.
•
While the washing machine fills, you may notice just hot and/or just cold water
going through the dispenser when cold or warm temperatures are selected.
This is a normal function of the automatic temperature control feature as the
washing machine determines the water temperature.
•
Use the High or Extra High spin speed.
•
Use high efficiency (HE) detergent to reduce oversudsing.
•
The load is too small. Small loads (one or two items) may become unbalanced
and not spin completely.
•
Make sure the drain hose is not kinked or clogged.
•
Make sure the door is properly closed.
•
Make sure all hose connections are tight.
•
Make sure the end of the drain hose is correctly inserted and secured to the
drain system.
•
Avoid overloading.
•
Use high efficiency (HE) detergent to prevent oversudsing.
•
Excessive suds collect in recesses and can cause foul odors.
•
Run cleansing cycles to sanitize periodically.
•
Clean the door seal (diaphragm).
•
Dry the washing machine interior after a cycle has finished.
•
Overloading may screen bubbles.
•
Severely contaminated laundry may not generate bubbles.
•
Make sure the Internet connection to your house is properly
established.
•
Make sure the router turns on and operates normally.
•
Make sure you have installed the latest version of the Smart Control
App.
English _31
2015/4/20 9:34:17
Advertisement
Table of Contents
