Table of Contents
Advertisement
4. Slide belt through slot in belt clamp.
5. Verify belt and insert are installed properly.
6. Pull belt tight and secure belt to clamp with the two set screws. Torque set screws 300-350
in-lbs.
7. Place weight stack pin in each plate to verify proper installation.
8. Without selecting any resistance, lift top weight up and down (simulating normal operation.)
9. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the
weight belt clamp.
10. Reinstall the six increment weights that were removed.
Cybex Owner's Manual
Insert and Set Screws (not
shown) are on this side.
Belt
Increment
Weight
Adjusting
Top Pulley
Knob
Correct
belt routing
Insert
Belt
Stem
Belt clamp
insert
Set screws
Wrong
belt routing
Insert
Belt
Stem
Belt
Belt clamp
14
Advertisement
Table of Contents
