CYBEX 11080-999-4 B Owner's Manual page 13

7. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
8. Install each weight plate one at a time. When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward.
9. Slide top weight onto guide rods.
10. Place lower snap ring and wave washer onto guide rod (about 3" from the top end of guide
rod.)
11. Raise guide rod up through mounting hole and install the upper snap ring.
12. Lower guide rod and secure lower snap ring. Repeat for the opposite guide rod.
Belt Routing
1. Verify belt is routed through top of pulley bracket and then route end of belt down to the top
weight.
2. Slide belt through slot in belt clamp.
3. Verify that the position of the belt clamp (on the top weight) is aligned properly with the top
pulley bracket (on the machine.) The belt must have a straight path from the pulley to the belt
clamp. Figure shows the top view, looking from the top pulley down to the top plate.
Cybex Owner's Manual
WIDE bushing
edge faces
upward
13
NOTE: The narrow
bushing edge must
face downward.
NARROW
bushing edge