Sony Cyber-shot RX10 II How To Use Manual page 179

Help Guide
The time code (TC) and the user bit (UB) information can be recorded as data attached to
movies.
1. MENU →
Menu item details
TC/UB Disp. Setting:
Sets the display for the counter, time code, and user bit.
TC Preset:
Sets the time code.
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to
NTSC.)
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1. MENU →
of the control wheel.
2. Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
*
When [24p] is selected, you can select the last two digits of the time code in
multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3. Set the other digits following the same procedure as in step 2, then press
center of the control wheel.
How to reset the time code
1. MENU →
of the control wheel.
2. Press the
file:///Z|/15-1h_HG/Kaihan_20151021_FV-ZV/Nouhin/Web/4574925122.w/en/print.html[10/27/2015 6:18:47 PM]
(Setup) → [TC/UB Settings] → setting value you want to change.
(Setup) → [TC/UB Settings] → [TC Preset], then press
(Setup) → [TC/UB Settings] →[TC Preset], then press
(Delete) button to reset the time code (00:00:00:00).
in the center
in the
in the center