Supero SuperServer 6113M-i User Manual page 37

Installing the Heatsink Retention Mechanism
1. Place the retention mechanism (SKT-0147-RM-IT2) on the serverboard as
shown in the picture below:
2. Secure the retention mechanism to the serverboard by screwing three 6-32,
4.5-mm screws into the mounting holes on the back of the serverboard. (Rec-
ommended torque: not to exceed 6 in-lbf.)
Figure 5-1. Installing Heatsink Retention Mechanism
Chapter 5: Advanced Serverboard Setup
1.) Place the retention
mechanism on the
serverboard.
2.) Screw in three 6-32
4.5-mm screws from the
reverse side of the
serverboard.
5-3