Table of Contents
Advertisement
Processors
The i2DMR-iG2 supports single or dual Intel Itanium2 processors of up to 1.50
GHz with a 6 MB L3 cache at a 400 MHz FSB. Please refer to the support
section of our web site for a complete listing of supported processors (http://
www.supermicro.com/TechSupport.htm).
Memory
The i2DMR-iG2 has eight 184-pin, DIMM slots that can support up to 16 GB of
low-profile, registered ECC DDR200 (PC1600) SDRAM. (DDR266 is supported
but at 200 MHz only.) Module sizes of 128 MB, 256 MB, 512 MB, 1 GB and 2
GB may be used to populate the DIMM slots. (This serverboard has has been
designed to support 2GB DIMM modules for each memory slot, but it has only been
validated with 1GB memory modules.)
PCI Expansion Slots
The i2DMR-iG2 has one 64-bit, 133/100 MHz PCI-X slot. A riser card is included
with the server. This riser card fits into the PCI-X slot and was designed specially
for the SC813Hi chassis to support the use of one standard size PCI card.
ATI Graphics Controller
The i2DMR-iG2 features an integrated ATI video controller based on the Rage XL
graphics chip. Rage XL fully supports sideband addressing and AGP texturing.
This onboard graphics package can provide a bandwidth of up to 512 MB/sec over
a 32-bit graphics memory bus.
Onboard Controllers/Ports
The i2DMR-iG2 includes two onboard IDE controllers, which support up to four
hard drives or ATAPI devices. Back panel I/O ports include two COM ports, four
USB ports and a VGA (monitor) port. An Intel 82546 Ethernet controller provides
support for two Gb LAN ports, which are also located on the back panel.
1-3
Chapter 1: Introduction
Advertisement
Table of Contents
