Fisher & Paykel COOLDRAWER RB9064S1 User Manual page 23

PROBLEM POSSIBLE CAUSES
Condensation Frequent or long drawer
inside the openings.
drawer
Drawer not sealing or
closing properly.
High humidity environment.
Drawer hard Appliance may not be level.
to open or
Slides not extending fully.
close. Tray or
bin hard to
pull out
Food or packaging
trapped.
Drawer not sealing or
closing properly.
Note: When drawer is set to 'freezer' mode slides will not move as freely
compared to other modes selected due to the lower temperatures.
Storage area
Temperature setting
too warm or not correct.
too cold
Frequent drawer
openings.
Warm, humid weather.
Drawer not sealing or
closing properly.
Large amount of food
recently added.
The food mode of the
drawer has recently been
changed.
Food freezing Temperature setting
when set to
not correct.
'fridge' mode
Food placed directly in
front of air outlets.
TROUBLESHOOTING
WHAT TO DO
Minimize drawer openings.
Move items around so drawer can
close tightly.
Check that seal is sitting flat and
sealing tightly.
Check that drawer skin is not clashing
with surrounding cabinetry.
May occur during periods of high
humidity. Wipe dry.
Refer to your Installation instructions sheet.
Hold onto sides of drawer or tray, extend
the slides fully and evenly by using a firm
pull on both sides. This will reset the slides.
Move items around so drawer can
close tightly.
Check that seal is sitting flat and
sealing tightly.
Refer to 'Adjusting the temperature'.
Minimize drawer openings to allow
temperature to stabilize.
Minimize drawer openings to allow
temperature to stabilize.
Move items around so drawer can close
tightly, and seal is sitting flat when closed.
Check that drawer panel is not clashing
with surrounding cabinetry.
Minimize drawer openings to allow
temperature to stabilize.
Wait for the food mode icon on control
panel to stop flashing and recheck
temperature.
Refer to 'Adjusting the temperature'.
Move chill sensitive foods away from the
back wall of the appliance.
23