SETUP
–
Secure the handlebar cushion with two cable binders.
601710-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
101019-01
(EXC‑F EU, EXC‑F AUS, EXC-F SIX DAYS)
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with connector that is marked
green.
601711-01
(350 EXC‑F USA)
–
Mount the license plate holder with the license plate lamp, turn signals, and
reflector.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with connector that is marked
green.
C00117-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-
ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery
800035-10
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. (
–
Install the battery. (
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
p. 11)
p. 10)
6