SETUP
(XCF‑W)
–
Insert the indicator lamp with the brown/red and yellow/blue cable colors
into socket
–
Insert indicator lamp LED with the white and orange cable colors into
socket
–
Connect pull switch
C00115-10
(All EXC‑F models)
–
Attach the retaining bracket for the connector, the turn signal bracket with
the turn signal, and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
401380-01
(XCF‑W)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis
401381-01
(All EXC‑F models)
–
Mount and tighten nuts
–
Connect connector
marked green.
–
Connect connector
marked red.
601705-10
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
(EXC‑F EU/AUS/USA, XCF‑W)
Screw, bottom triple clamp
(EXC‑F EU/AUS/USA, XCF‑W)
Screw, top triple clamp (EXC-F SIX
601707-10
DAYS)
Screw, bottom triple clamp (EXC-F
SIX DAYS)
Info
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position bleeder screws
.
3
.
4
with the yellow and white cables.
5
of the turn signals on both sides.
6
of the right turn signal with connector
7
of the left turn signal with connector
9
toward the front.
bl
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
, which is
8
, which is
bk
M8
20 Nm
(14.8 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M8
17 Nm
(12.5 lbf ft)
M8
12 Nm
(8.9 lbf ft)
4