Product Care - Dometic DMR702 Installation & Operating Instructions Manual

Hide thumbs Also See for DMR702:
Table of Contents

Advertisement

STORAGE COMPARTMENTS
AIRING POSITION
Use the Airing Position to keep the doors ajar if the refrigerator will not be in use for an extended period of time
or put into storage.
Put the door in airing position by:
(1) Open the door.
(2) Turn the integrated flap in the door handle to it's end position.
(3) Close the door with the flap in it's end position.
1

PRODUCT CARE

CLEANING
Always keep the refrigerator clean. Cleaning the refrigerator
is usually done after it is defrosted or put into storage. Use
lukewarm weak soda solution to clean the interior liner of the
refrigerator. Use warm water only to clean the finned evapora-
tor, gasket, ice tray and shelves.
NOTE! Never use strong chemicals or abrasives to clean these
parts, as the protective surfaces will be damaged. Do not spray
liquids near electrical outlets, connections or the refrigerator
components.
To keep the refrigerator operating efficiently and safely, peri-
odic inspection and cleaning of several components once or
twice a year is recommended:
• Check the lower vent, upper vent and area between these
openings for any obstructions such as bird/insect nests,
spider webs, etc.
• Make sure the refrigerator area is free from combustible
material, gasoline and other flammable vapors or liquids.
• Clean the coils on the back of the refrigerator. Use a soft
bristled brush to dust off the coils.
2
DEFROSTING
1. Shut off the refrigerator by pressing the main power
ON/OFF button.
2. Empty the refrigerator.
3. Leave the cabinet and freezer doors open and place
the drip tray under the finned evaporator.
Defrosting time can be reduced by filling the ice
trays with hot water and placing them in the freezer
compartment.
Do not use:
• A knife or an ice pick, or other sharp
tools to remove frost from the freezer
shelves. It can create a leak in the am-
monia system.
• A hot air blower. Permanent damage
could result from warping the metal or
plastic parts.
4. When all the frost has melted, dry the interior with a
clean cloth.
5. Replace the food. Set the thermostat to the coldest
setting for a few hours. Then, reset the thermostat to
the desired setting, usually at mid setting.
- 15 -
3
CAUTION

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmc702

Table of Contents