Listening To The Radio - Sharp HT-SB600 Operation Manual

Listening to the radio

Note:
This product can receive FM stereo/FM monaural/AM
broadcasts.
Tuning
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the INPUT button on the main unit or
TUNER(BAND) button on the remote control
repeatedly to select the desired frequency band
(FM Stereo/FM Mono/AM).
3
Press the (TUNING
the desired station.
Manual tuning:
Press the (TUNING
required to tune in to the desired station.
Auto tuning:
When the (TUNING
more than 0.5 seconds,
automatically and the tuner will stop at the first
receivable broadcast station.
Notes:
●
When radio interference occurs, auto scan tuning may
stop automatically at that point.
●
Auto scan tuning will skip weak signal stations.
●
To stop the auto tuning, press the TUNING button
again.
To receive an FM stereo transmission:
●
" " will appear when an FM broadcast is in stereo.
●
If the FM reception is weak, press the TUNER(BAND)
button to extinguish the "ST" indicator. The reception
changes to monaural, and the sound becomes clearer.
FM stereo mode indicator
FMST
FM stereo receiving indicator
HDMI
ARC
1 2 3
TV
DIGITAL LINE
1 2 1 2
CLOCK TIMER
DIMMER TUNING TUNER(BAND)
EQUALIZER X-BASS BASS/TREBLE MUTE
TUNING
or ) button to tune in to
or ) button as many times as
or ) button is pressed for
scanning will
Listening to the radio (continued)
Memorizing a station
You can store 40 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 18.
2
Press the ENTER button to enter the preset tuning
saving mode.
3
Within 5 seconds, press the PRESET (
buttons to select the preset channel number.
Store the stations in memory, in order, starting with
preset channel 1.
4
Within 5 seconds, press the ENTER button to
store that station in memory.
If the preset number indicators disappear before the
station is memorized, repeat the operation from step
2.
5
Repeat steps 1 - 4 to set other stations, or to
change a preset station.
When a new station is stored in memory, the station
previously memorized will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
To recall a memorized station
start
Press the PRESET (
seconds to select the desired station.
To erase entire preset memory
1. Hold the TUNER(BAND) button on the remote control
for 4 seconds or more.
2. While "CLEAR" is flashing, press the ENTER button.
E-18
or
) button for less than 0.5
or
)