General Control - Sharp HT-SB500 Operation Manual

General control

To turn the power on
Press the ON/STAND-BY button on the remote control or touch
anywhere on the display panel. All the indicators will be
displayed to indicate pad positions.
The power indicator turns green. If the power does not turn
on, check whether the power cord is plugged in properly.
To set the speaker to stand-by mode:
Press the ON/STAND-BY button again on the remote control
or touch ON/STAND-BY pad on the speaker.
The STAND-BY indicator turns orange.
Display brightness control
Press the DIMMER ON/OFF button to adjust the brightness of
the display and sound mode indicator.
Sound mode indicator and display bright. Display will off after 5
seconds without any button/pad operation.
Sound mode indicator and display dim. Display will off after 5
seconds without any button/pad operation.
If you turn off and on the speaker with the volume set to 40 or
higher, the volume starts at 20 and fades in to the last set level.
Speaker operation:
Touch volume up pad to increase the
volume and touch volume down pad
VOL VOL
to decrease the volume.
Remote control operation:
Press the VOLUME + button to increase the volume and the
VOLUME – button to decrease the volume.
The volume is muted temporarily when pressing
the MUTE button on the remote control. Press
again to restore the volume.
Speaker operation:
Touch a desired sound mode on the speaker.
Remote control operation:
Press a desired sound mode on the remote control.
NEWS
CINEMA/GAME TruSurround HD on for cinema/game
SPORT
STANDARD
Volume auto fade-in
Volume control
Muting
Preset sound mode
TruSurround HD on for news
sound effect
TruSurround HD on for sport broadcasting
TruSurround HD on for standard sound
effect
HT-SB500
00 01 02 ..... 59 60
19