Horizontal Position - Sharp HT-SB500 Operation Manual

Speaker preparation (continued)
To mount the speaker on the wall
Caution:
Be very careful to prevent the speaker [4.84 lbs. (2.2 kg)] from
falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The speaker may fall.) If
unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the
speaker may get damaged.
SHARP is not responsible for accidents resulting from
improper installation.
Driving screws
SHARP designed the speakers so you may hang them on the
wall. Use proper screws (not supplied). See below for size and
type.
1/8" (3.2 mm)
3/16"
(5 mm)
Min. 7/8" (22 mm)
3/8" (9 mm)
Wall mount angle fixed to the wall

(Horizontal position)

1
Fix the pattern paper to the wall in horizontal position
as below.
20-1/32" (509 mm)
1-3/4 " ( 44 mm)
Wall surface
1-1/8 " (29 mm)
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
1-3/4 " ( 44 mm)
1-1/8 " (29 mm)
Pattern paper
(Continued to the next page)
HT-SB500
11