Adjusting The Height-Of-Cut; Selecting The Steering Mode - Toro Groundsmaster 360 Operator's Manual

1. PTO switch
Disengaging the PTO
To disengage, push the PTO switch to the

Adjusting the Height-of-Cut

The height-of-cut is adjusted from 2.5 to 15.8 cm (1 to
6 inches) in 6 mm (1/4 inch) increments by relocating the
stop pin into different hole locations.
1. With the engine running, push back the deck-lift switch
until the mower deck is fully raised and release the
switch immediately
2. Rotate the stop pin until the nub on it lines up with
the slots in the holes in the height-of-cut bracket and
remove it (Figure 26).
3. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, insert the pin, and rotate it
down to lock it in place
Note: There are 4 rows of hole positions
The top row gives you the height of cut listed above the
pin. The second row down gives you the height listed
plus 6 mm (1/4 inch). The third row down gives you
the height listed plus 12 mm (1/2 inch). The bottom
row gives you the height listed plus 18 mm (3/4 inch).
For the 15.8 cm (6 inch) position, there is only 1 hole,
located in the second row. This does not add 6 mm
(1/4 inch) to the 15.8 cm (6 inch) position.
Figure 25
position.
OFF
(Figure 26).
(Figure 26).
(Figure
g014178
1. Stop pin
4. Adjust the anti-scalp rollers and skids as required.

Selecting the Steering Mode

4-Wheel Drive Only Machines
For maximum trimming and minimum turf damage, always
operate the machine in 4-wheel steering. However, to
transport the machine on roads or trails, you can switch the
machine to 2-wheel steering.
26).
1. Steering-selector switch
29
Figure 26
Figure 27
g014263
g014390