Table of Contents
Advertisement
3-2. Setting up in Access Point mode
Complete the setting up in the Access Point mode within
10 minutes.
To enter the mode
(1) Hold down the Temperature
for 5 seconds.
(2) Select "¯ 1" by pressing
Temperature
and
on the right.
(3) Point the remote controller
toward the indoor unit unit and
press the
.
3-2.1. Connect your smartphone to the air conditioner.
Make sure that the LED (Air purifying lamp of the
indoor unit) indication is as shown below.
On the Wi-Fi Setting Screen on your smartphone,
select SSID and enter KEY, which are printed on the
information label.
MAC:
XXXXXXXXXXXX
ID:
XXXXXXXXXX
SSID:
SSID:
ME-XXXXXXXXXX
ME-XXXXXXXXXX
KEY:
KEY:
XXXXXXXXXXXX
XXXXXXXXXXXX
E.O.
SW
Wi-Fi module
Other
Smartphone
NOTE:
• Check Wi-Fi setting of your smartphone if SSID does not
appear on it.
• Enter KEY again if SSID appears on your smartphone,
but it cannot connect to the Wi-Fi module.
• The LED (Air purifying lamp of the indoor unit) indication
does not change or blinks 5 times if connection fails. In
that case, reset connection and set up the Wi-Fi module
and the router again.
3-2.2. Access URL (http://192.168.11.1/network) by any of
the following methods to display the setting screen.
(1) Scan the matrix barcode below.
(2) Scan the matrix barcode on the information label.
(3) Type the URL (http://192.168.11.1/network) in the
web browser.
Information label
MAC:
XXXXXXXXXXXX
ID:
XXXXXXXXXX
SSID:
ME-XXXXXXXXXX
KEY:
XXXXXXXXXXXX
Other
E.O.
SW
Wi-Fi module
OBH766G
Access Point mode
as shown
Connecting
The LED (Air purifying lamp of
the indoor unit) lights up for
3 seconds then blinks once.
A beep sounds as the LED blinks.
This series of actions is repeated.
3-2.3. Register the information of the router on the air
conditioner.
In the displayed window, select Dynamic in
DHCP (*1)and enter the information of router,
then tap the Submit button.
(*1)
Router
NOTE:
• If you want to use Static, select Static in DHCP (*1) and
enter the information of router and network, then tap the
Submit button.
3-2.4. LED (Air purifying lamp of the indoor unit) indica-
tion will be as shown below when connection
between the router and Wi-Fi module is completed
and connection to MELCloud starts.
Connected
Connecting
NOTE:
It may take several minutes to show the indication above.
The LED (Air purifying lamp of the indoor unit) indication
does not change or blinks 5 times if connection fails.
In that case, reset connection and set up the Wi-Fi module
and the router again.
23
Connecting
smartphone
The LED (Air purifying lamp of the indoor
unit) lights up for 5 seconds and then a beep
sounds for 1 second.
Connected
Advertisement
Table of Contents
