Ryobi RY142300VN Operator's Manual page 16

Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
WARNING:
NEVER remove nozzles without first turning off the motor,
disconnect from power supply, relieving the water pres-
sure in the trigger handle, and locking the lock out on the
trigger handle. NEVER point the nozzle at your face or at
others. The quick-connect feature contains small springs
that could eject the nozzle with some force. Failure to
follow these instructions could result in an eye injury or
other serious personal injury.
To connect a nozzle to the spray wand:
 Turn off the pressure washer, disconnect from power
supply, and shut off the water supply. Pull trigger to
release water pressure.
 Engage the lock-out on the trigger handle by pushing up
on the lock-out until it clicks into the slot.
 Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.
 Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the spray wand once the
cleaning job is complete:
OPERATION
NOZZLE SELECTION GUIDE
(NO SOAP WHEN USING THESE NOZZLES)
 Recommended Nozzle
12 — English
HIGH PRESSURE
Turbo Nozzle

Use With Caution for Certain Applications

 Turn off the pressure washer, disconnect from power
supply, and shut off the water supply. Pull trigger to
release water pressure.
 Engage the lock-out on the trigger handle by pushing up
on the lock-out until it clicks into the slot.
 Pull back and hold the quick-connect collar.
 Remove the nozzle by pulling it from the quick-connect
collar. Place nozzle in the nozzle storage area on the top
of the machine.
USING THE HIGH PRESSURE HOSE
WARNING:
Injection hazard. Fully unwrap and straighten high pres-
sure hose prior to and during each use and do not allow
it to become kinked. The high pressure hose features an
outer covering that provides strength to the hose. If the
outer covering becomes damaged, stop using the hose
and replace it immediately. A kinked or damaged hose
can develop a high pressure leak and result in a possible
injection or other serious personal injury.
To prevent damage to the outer covering:
 Inspect the hose before every use.
LOW PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Blue or Black
15º
Soap Nozzle
 
 
 
 