Chevrolet Suburban 2007 Owner's Manual page 274

TIGHTEN GAS CAP
If the vehicle's fuel cap is not tightened properly,
this message may display along with the check
engine light on the instrument panel cluster.
See Malfunction Indicator Lamp on page 248.
Reinstall the fuel cap fully. See Filling the Tank on
page 445. The diagnostic system can determine
if the fuel cap has been left off or improperly
installed. A loose or missing fuel cap will allow fuel
to evaporate into the atmosphere. A few driving
trips with the cap properly installed should turn this
light and message off.
TIRE LEARNING ACTIVE
If your vehicle has a Tire Pressure Monitor (TPM)
system, this message will display when the
system is re-learning the tire positions on your
vehicle. See DIC Operation and Displays
(With DIC Buttons) on page 256 or DIC Operation
and Displays (Without DIC Buttons) on page 262
for more information. The tire positions must
be re-learned after rotating the tires or after
replacing a tire or sensor. See Tire Inspection and
Rotation on page 515, Tire Pressure Monitor
System on page 510, and Inflation - Tire Pressure
on page 509 for more information.
274
TRACTION CONTROL OFF
If your vehicle has StabiliTrak
display when the traction control system is
turned off. Adjust your driving accordingly. See
®
StabiliTrak System on page 357 for more
information.
TRANSMISSION HOT IDLE ENGINE
Notice: If you drive your vehicle while
the transmission fluid is overheating and the
transmission temperature warning is displayed
on the instrument panel cluster and/or DIC,
you can damage the transmission. This could
lead to costly repairs that would not be
covered by your warranty. Do not drive your
vehicle with overheated transmission fluid
or while the transmission temperature warning
is displayed.
If the transmission fluid in the vehicle gets hot, this
message will display along with a continuous
chime. Driving with the transmission fluid
temperature high can cause damage to the
vehicle. Stop the vehicle and let it idle to allow the
transmission to cool. This message will clear
and the chime will stop when the fluid temperature
reaches a safe level.
®
, this message will