Sharp AR-M237 Software Setup Manual page 9

When the interface selection screen
appears, select "USB" and click the
"Next" button.
In Windows 2000, if the following
Caution
screen appears while the files are
being copied (the message may
appear more than once), click the
"Yes" button.
When "The installation of the SHARP
software is complete" appears, click the
"OK" button.
10
Begin the installation of the PC-FAX
driver (if "PC-FAX Driver" was selected
in Step 7).
Follow the on-screen instructions.
• When the model selection window
appears, select model name of your
machine.
• During installation of the PC-FAX driver,
you will be asked to select the port. If
you are using the USB port, select any
port (such as LPT1) and continue the
installation. The port settings are
configured in the PC-FAX driver
properties after installation. (p. 12)
INSTALLING THE SOFTWARE
Click the "Finish" button when the
message informs you that setup is
successful.
11
When the "Finish" screen appears,
click the "Close" button.
When "After Windows system restarts,
connect the interface cable to the PC"
appears, click the "OK" button.
After the installation, a message
Note
prompting you to restart your
computer may appear. In this case,
click the "Yes" button to restart your
computer.
12
Make sure that the power of the
machine is turned on, and then
connect the USB cable. (p. 10)
Windows will detect the machine and the
Plug and Play screen will appear.
13
Follow the instructions in the Plug and
Play screen that appears in your
version of Windows to begin the
installation.
This completes the installation of the
software.
• If you installed the printer driver, configure
the printer driver settings as explained in
"CONFIGURING THE PRINTER DRIVER"
(p. 11).
• If you installed the PC-FAX driver, configure
the PC-FAX driver settings as explained in
"CONFIGURING THE PC-FAX DRIVER
WHEN USING A USB CABLE (if the PC-FAX
driver is installed)" (p. 12).
7