Back Panel Connectors - Gigabyte Z590 VISION D User Manual

1-7

Back Panel Connectors

DisplayPort In Port
The DisplayPort In port offers video outputs to the motherboard. Refer to the pictures below and the
Thunderbolt 4 Connector introduction for more information.
™
Step 1:
Connect your DisplayPort cable or Mini-DisplayPort
cable (purchased separately) from the graphics
card to the DisplayPort In port on the back panel.
HDMI Port
output. You can use this port to connect your HDMI-supported monitor. The maximum supported
resolution is 4096x2160@30 Hz, but the actual resolutions supported are dependent on the monitor
being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(The item name may differ depending on your operating system.)
SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
Tighten the antennas to the antenna connectors and then aim the antennas correctly for better
signal reception.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
The HDMI port supports HDCP 2.3 and Dolby TrueHD and DTS HD Master
Audio formats. It also supports up to 192KHz/16bit 7.1-channel LPCM audio
- 21 -
Step 2:
Then connect the DisplayPort or Thunderbolt
devices to VisionLINK TB connector to complete.
Hardware Installation
™