Gigabyte Z590 VISION D User Manual page 29

10) NOISE_SENSOR (Noise Detection Header)
This header can be used to connect a noise detection cable to detect the noise inside the case.
11) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
BUG DEBUG
RT PORT
For more information on the noise detection function, refer to the instructions in Chapter 5, "Unique
Features," "APP Center\System Information Viewer"
Before connecting the cable to the header, make sure to remove the jumper cap; re-place the
jumper cap if the header is not in use.
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATA And RST Configuration," for more information.
1
Noise Detection
Cable
1
SATA3 5 3 1
4 2 0
- 29 -
Pin No. Definition
1 Noise Detection
2 GND
Chipset supports RAID 0,
®
Pin No. Definition
1 GND
1
2 TXP
1
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Hardware Installation