Front Wheel Camber; To Start Engine With A Weak Battery; To Remove Wheel For Repairs - Craftsman 917.275021 Owner's Manual

23.0 hp electric start 48" mower automatic garden tractor
Table of Contents

Advertisement

FRONT WHEELCAMBER
• The
front wheel camber is not adjustable
on your tractor. If damage has occurred to
affect the front wheel camber, contact
contact a Sears or other qualified service
center
A
Adjustment Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONTWHEEL-
1. Block up axle securely.
2. Remove
axle cover, retaining
ring and
washers
to allow wheel removal.
3.
Repair tire and reassemble.
4.
Replace washers
and snap retaining
ring securely
in axle groove.
5. Replace axle cover.
REAR WHEEL -
1. Block rear axle securely.
2. Remove five (5) hub bolts to allow
wheel removal.
3. Repair tire and reassemble.
Replace
and tighten hub bolts securely.
NOTE: To seal tire punctures
and prevent
fiat tires due to slow leaks, tire sealant
may be purchased
from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
Washem
Retaining
Ring'
Axle
Cover
TO START ENGINE WITH A WEAK
BATTERY
_hbcAIJTION:
Lead-acid batteries generate
explosive gases. Keep spanks,flame and
smoking materials away from batteries.
Always wear eye protection when around
batteries.
If your battery is too weak to startthe engine, it
should be recharged. (See "BA'I-I'ERY" in the
MAINTENANCE
section of this manual).
If "jumper cables" are used for emergency
starling, follow this procedure:
IMPORTANT: Your tractor is equipped with a
12 volt negative grounded system. The other
vehical must also be a 12 volt negative
grounded system. Do not use your tractor
battery to start other vehicles.
TO A'I-rACH JUMPER CABLES -
1. Connect each end of the RED cable to
the POSITIVE
(+) terminal of each
battery, taking care not to short
against chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE
(-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both battedes.
"Positive"
=Negative"
(+)
(-)
L.H. o
28

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents