Table of Contents
Advertisement
NOTE: Afterinstalling a newelectric
clutch,runtractorat
full throttle and
engage and disengage electric clutch 10
cycles to wear in clutch plate.
Clutch F
.012"
Slot (3) -
" Brake
Plate
Nylon Locknut (3)
TO REPLACE
MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake.
For ease of service there
is a belt installation guide decal on
bottom of left footrest.
1. Remove mower (See =TO REMOVE
MOWER" in this section of this
manual.)
BELT REMOVAL -
2. Create slack in belt by removing
retainer spring from drive belt tension
handle.
3.
Remove belt from all idler pulleys,
transaxle pulley and then from engine
pulley.
Retainer
Drive
Tension
Handle
Engine Pulley
Transaxle Pulley
Belt
Keeper
Clutching
Keeper V-Idler
Clutching
Flat Idler
Idler
BELT INSTALLATION -
1. Install new belt around engine pulley
first, then around transaxle
pulley and
lastly into all the idler pulleys.
2. Check to be sure belt is positioned
correctly and is on proper side of all
belt keepers.
3. Engage the ddve belt tension handle
and replace the retainer spring.
4. Reinstall
mower.
TRANSAXLE
MOTION CONTROL
LEVER NEUTRAL
ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
1. Park Tractor on level surface. Stop
tractor by turning ignition key to "OFF"
position and engage parking brake.
2. Loosen the adjustment bolt in front of
the right rear wheel.
3. Move motion control lever to the
neutral position.
4. Tighten the adjustment bolt.
_
AdjustmentBolt
TRANSMISSION
REMOVAL/REPLACE-
MENT
Should your transmission require
removal for service or replacement, it
should be purged after reinstallation and
before operating the tractor. See
"PURGE TRANSMISSION"
in the
Operation section of this manual.
TO ADJUST
STEERING
WHEEL ALIGN-
MENT
If steering wheel crossbars are not
horizontal (left to right) when wheels are
positioned straight forward,
remove
steering wheel and reassemble
per
instructions in the Assembly section of
this manual.
FRONT WHEEL TOE-IN ADJUSTMENT
Front wheel toe-in is required for proper
steering operation.
Toe-in was set at the
factory and adjustment should not be
necessary.
If parts in the front axle or
steering mechanism have been replaced
or damaged, check toe-in and adjust if
necessary.
TO CHECK
TOE-IN
-
1. Position front wheels straight ahead.
2. Measure distance between wheels at
front and rear of tires (dimensions °A"
and "B").
• Front dimension "A" should be 1/8" to
1/4" less than rear dimension =B".
TO ADJUST
TOE-IN
-
1. Loosen jam nuts at adjustment
sleeves on tie rod.
2. Adjust tie rod until dimension =A" is
118" to 1/4" less than dimension
"B".
27 3 . Tighten jam nuts securely.
Hide quick links:
Advertisement
Table of Contents
