Connections; Connecting To A Tv - Toshiba DR20KB Owner's Manual

E7TE0BD_EN.book Page 16 Friday, March 5, 2010 5:08 PM

Connections

Connecting to a TV

Connect the unit to a TV after considering the capabilities of
your existing equipment.
Before installation, unplug your TV and
this unit
Cable
Signal
Antenna
or
RF cable
(not supplied)
1
1
Connect the antenna or cable to the ANTENNA
IN jack of this unit.
2
Connect the ANTENNA OUT jack of this unit to
the Aerial jack of your TV.
Using the Scart socket
Audio/video cable
(not supplied)
Scart/RCA cable (not supplied)
Scart adaptor
(not supplied)
Connect AV1 (TV) Scart socket of this unit to
the Scart socket of your TV.
Note
• If your TV does not have a Scart socket, use a Scart/RCA
cable to connect.
• Connect this unit directly to the TV. If the AV cables are
connected to a VCR, pictures may be distorted due to the
copy protection system.
16
EN
• When changing the "Video Out" setting ("SCART (RGB)",
If your TV has component video input jacks, use a component
video cable (to connect the COMPONENT VIDEO OUTPUT
jacks) and an audio cable (to connect the AUDIO OUT
(ANALOG L R) jacks).
When using this type of connection, "Video Out" setting
should be set to "Component (Progressive)" or "Component
To Aerial jack
(Interlace)". Refer to "Video Out" on page 66.
• Component connection provides the better quality picture.
RF cable
(supplied)
2
Scart cable
• After you have made the connections, set the "Video Out"
(not supplied)
Selecting Progressive Scan (576p/480p or
Interlaced 576i/480i) Playback
• If your TV is compatible with progressive scanning (576p/
• If your TV is not compatible with progressive scan, set
• Use a commercially available adaptor if the video input jacks
• Only component and HDMI connections are compatible with
"Component (Interlace)" or "Component (Progressive)"),
connect to the corresponding jack on the TV. If the setting is
changed, for example, to "Component (Interlace)" or
"Component (Progressive)" while the scart cable is
connected to the TV, a distorted video signal may be output.
Using the COMPONENT VIDEO OUTPUT
Jacks and the AUDIO OUT
(ANALOG L R) Jacks
Audio IN
Audio cable
2 (not supplied)
1
Connect the COMPONENT VIDEO OUTPUT
jacks of this unit to the component video input
jacks of your TV.
2
Connect the AUDIO OUT (ANALOG L R) jacks
of this unit to the analogue audio input jacks of
your TV.
setting. (See page 66.)
480p), connect the TV to the COMPONENT VIDEO
OUTPUT jacks of this unit and set "Video Out" setting to
"Component (Progressive)" in "Setup" menu. (See page 66.)
Next, set your TV to the progressive scan mode.
"Video Out" setting to "Component (Interlace)".
of your TVs or monitors are the BNC type.
the Progressive Scan.
Component
video IN
Y P /C P /C
B B R R
Component
video cable
1
(not supplied)