Using Device - Lenovo IdeaCentre Q700 Hardware Maintenance Manual

Using Device

3. The password dialog box will be displayed. Type the new password, and
press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set Power-On Password, do the following :
1. From the Security menu, select Set Power-On Password and press
Enter.
2. The password dialog box will be displayed. Press Enter in New Password
and confirm New Password dialog. A setup notice will display that
changes have been saved.
3. Select Exit.
4. Select Save changes and Exit.
USB Setup
To set Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program"
on page 16).
2. From the Setup Utility program menu, select Devices.
3. Select USB Setup.
4. Select Disabled or Enabled and press Enter.
5. Return to the Setup Utility program menu and press F10 to save
configuration changes and exit setup.
Note
If you do not want to save the settings, select Discard changes and
Exit.You can set others such as ATA Drives Setup , Video Setup ,
Audio Setup , Network Setup , CIR Setup . See the information
displayed on the right side of the screen.
Chapter 5. Using the Setup Utility
When this feature is set to Disable,
the device of USB Setup is
disabled and will not be displayed in
the system configuration.
19