1050 Hard Disk Drive Assembly - Lenovo V480 Hardware Maintenance Manual

Note: If only one memory module is used on the computer you are servicing, the card must be installed in
SLOT-0 ( a : lower slot), but not in SLOT-1 (
When installing: Insert the notched end of the memory module into the socket. Press the memory module
firmly, and pivot it until it snaps into place. Make sure that it is firmly installed in the slot and does not
move easily.

1050 Hard disk drive assembly

For access, remove these FRUs in order:
• "1010 Battery pack" on page 43
• "1020 Bottom slot cover" on page 44
Attention:
• Do not drop the drive or apply any physical shock to it. The drive is sensitive to physical shock. Improper
handling can cause damage and permanent loss of data.
• Before removing the drive, have the user make a backup copy of all the information on it if possible.
• Never remove the drive while the computer is operating or is in suspend mode.
Removal steps of hard disk drive assembly
1
Remove the screw , then pull the tab in the direction shown by the arrow
Step Screw (quantity)
1
M2 × 3 mm, flat-head, nylon-coated (1)
b : upper slot).
2
.
Color Torque
Black 1.6 kgfcm
.
Chapter 7 Removing and replacing a FRU
47