Separation Rubber Holder Assy - Brother DCP-7057 Service Manual

9.10.8 Separation Rubber Holder ASSY

(1) Release the pins to remove the separation rubber holder ASSY.
(2) Remove the ADF spring.
(3) Remove the support film.
Assembling Note:
• Noise may be caused if the front edge of the support film is not within the upper
document chute ASSY SX.
Check that there is the front edge of the support film at the position as shown in the
figure below.
Separation rubber holder ASSY
Pin
Support film
Separation rubber
Support film
Pin
Fig. 3-36
Support film
Upper document chute ASSY SX
NG
OK
Fig. 3-37
3-52
ADF spring
Support film
Confidential