Table of Contents
Advertisement
Adjusting the bass roll-off frequency – "LOWCUT"
To reduce unwanted low-frequency noise such as wind and handling noise, you can activate a
low-cut filter. The low-cut frequency is 120 Hz.
If you do not want to reduce low-frequency signal portions, select the setting "FLAT".
Selecting the standard display – "VIEW"
Via the "VIEW" menu, you can select one of the following standard displays:
RF
MHz
Transmission
frequency "FREQ"
The selected standard display is shown
•
after switch-on,
•
after the menu settings have been displayed for 10 seconds in display mode.
Loading the factory-preset default settings – "RESET"
Via the "RESET" menu, you can load the factory-preset default settings. After the reset, the
standard display is shown on the LC display panel.
Function
Low-cut frequency
Microphone sensitivity
Name
Standard display
Autolock function
Channel
Output power
Frequencies in the frequency bank "VAR" are reset.
RF
CH
CH
Channel
"CHAN"
Setting
"FLAT"
"0
"SK5212"
Transmission frequency
deactivated
"FIX
"PWR.HI"
Adjustment tips for the operating menu
RF
Name
"NAME"
dB"
01"
23
Advertisement
Table of Contents
