INSTALLER CHECKLIST
TO BE COMPLETED BY THE INSTALLER
Have the packaging and transit bolts and rods been removed?
Is the washer correctly levelled, feet are extended and cabinet corners are clear of
the floor?
Is the drain hose threaded through the hose guide 'U bend' (with no more than 20mm
extended) and hooked into your standpipe or tub, or attached to a spigot?
Have the taps been turned on?
Is the hot hose connected to the hot valve marked 'H'?
Is the cold hose connected to the cold valve marked 'C'?
Has the power cord been connected to an appropriate power supply and the power
turned on?
Have you performed the test cycle?.
Complete a
cycle with a half-load amount of detergent and without a load
DRUM CLEAN
to remove any residues remaining in the washer from the manufacturing process.
Complete and keep for safe reference:
Model
Serial no.
Purchase date
Purchaser
Dealer address
Installer's name
Installer's signature
Installation company
Installation date
SPARE PARTS
SPARE PARTS*
Hose(s) inlet long (2 m)
Hose(s) inlet large bore
* Available from your Fisher & Paykel dealer or a Fisher & Paykel trained
and supported service technician
PART NO.
422680P
426123P
11