Kenmore 110.26132410 Use & Care Manual page 18

First try the solutions suggested here for assistance and to possibly avoid a service call�
If you experience
Washer not performing as expected (cont.)
Incorrect dispenser
operation
Powdered detergent
not dissolving completely
in load
Single-dose laundry
packet not dissolving
Error Code Appears in Display
LF (too long to fill) or
F8E1 appears in display
"--"
F## code (F-type error
code) appears in display
F8E6 code (water
hazard) will appear
on display
18
TROUBLESHOOTING
Possible Causes
Clogged dispensers or laundry
products dispensing too soon�
Liquid chlorine bleach not used
in dispenser�
Using too much HE detergent�
Water temperature is very cold�
Adding laundry packet incorrectly�
Washer taking too long to fill. Drain
extends more than 4.5" (114 mm) into
standpipe�
Water supply not connected or turned
on�
Cycle knob is not on cycle�
System error code�
Lid is left open for more than
10 minutes and water has
pumped out�
Do not overfill dispenser. Overfilling causes immediate dispensing.
Always select Fabric Softener option to assure proper dispensing�
Load dispensers before starting a cycle�
It is normal for small amounts of water to remain in dispenser
at the end of the cycle�
Homes with low water pressure may result in residual powder
in the dispenser� To avoid, select a warmer wash temperature
if possible, depending on your load�
Use only liquid chlorine bleach in the bleach dispenser�
Follow the manufacturer's instructions to determine the amount
of detergent to use�
Select a warmer wash temperature�
Try adding the detergent to the basket prior to adding laundry,
rather than using the detergent dispenser�
Be sure laundry packet is added to washer basket before adding
clothes� Follow the manufacturer's instructions to avoid damage
to your items�
Check plumbing for correct drain hose installation� Use drain hose
form and attach securely to drainpipe or tub� Do not tape over
drain opening� See Installation Instructions�
Check water supply to make sure hoses are connected and/or
turned on�
This is not an error� The selector knob is not on a cycle� Rotate
your selector knob until a cycle lights up�
Touch START/PAUSE/Unlock Lid once to clear the code� Then
touch START/PAUSE/Unlock Lid again to restart washer� If code
appears again, call for service�
Make sure lid is closed before starting a cycle and/or during
prewash (soak).
Check plumbing for correct drain hose installation� Use drain hose
form and attach securely to drainpipe or tub� Do not tape over
drain opening� See Installation Instructions�
Solution