Kenmore 110.26132410 Use & Care Manual page 11

8.
Select cycle
Turn cycle knob to choose your wash cycle�
9.
Select cycle modifi ers, if desired
Light soils Moderate soils
Colors that bleed
or fade
Once you select a cycle, the default settings for that cycle will
be lit. Touch the cycle modifi er buttons to change the Wash
Temp, Soil Level, and Spin Speed, if desired� Not all settings are
available with all cycles� Even for cold wash settings, some warm
water may be added to the washer to maintain a minimum
temperature�
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items� If not sure which temperature to
use, refer to the diagram above or select a cooler temperature�
Heavy Soils
Bright colors Whites
Pastels
10
.
Select cycle options
Steam model shown
Select any other cycle options you may wish to add if not
previously set� Some cycles will automatically add certain
options such as Two Rinses. These may be turned off ,
if desired�
NOTE: Not all options are available with all cycles�
11.
Touch and hold START/PAUSE/Unlock Lid
to begin wash cycle
Touch and hold START/PAUSE/Unlock Lid button for up to
3 seconds to start the wash cycle. When the cycle has fi nished,
the Complete indicator will light and the end of cycle signal
will sound (if set). Promptly remove items when cycle is done
to avoid odor, reduce wrinkling, and avoid rusting of metal
hooks, zippers, and snaps�
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed items:
Touch START/PAUSE/Unlock Lid to pause washer; the lid will
unlock once the washer movement has stopped� This may take
several minutes if the load was spinning at high speed� Then
close lid and touch and hold START/PAUSE/Unlock Lid again
for up to 3 seconds to restart the cycle�
IMPORTANT: If lid is left open for more than 10 minutes,
the water will pump out and F8E6 error code will appear
on the display�
11