Table of Contents
Advertisement
Operations
Getting ready
The mop pad may have already come
attached to the mop head, if not follow
steps 1a and 1b below.
1. Attach mop pad
a. Set mop head in mop pad, making
sure toggle is located on the back.
b. Tighten mop pad by pulling on
elastic cord while pressing on toggle.
2. Fill the water tank
a. Remove tank by lifting straight up
and away from unit.
b. Unscrew cap at bottom of water tank.
c. Fill water tank with water. For best results,
water should be at room temperature.
d. Replace the cap, tighten until snug.
e. Replace water tank by gently sliding
tank into place.
3. Twist the quick release cord wrap clockwise to
unwrap the power cord completely and plug into
a 120-Volt outlet as described on the Important
Safety Instructions, page 2.
4. The indicator light will illuminate red when
the steam mop is plugged in. After about 20
seconds, the light will illuminate green when
the steam mop is ready to use.
NOTE: Upon first use of the steam mop or first
use after refilling the water tank, the pump
may make a "knocking" sound. This is normal
and should only last a few seconds. While in
use, the pump will continue to make a soft
"knocking" sound. This is also normal.
1a.
2a.
2d.
» Use of distilled water is
recommended to prolong the
life of your steam mop.
www.BISSELL.com
1b.
2b.
2e.
Tip
7
Advertisement
Table of Contents
