Supermicro X11DSN-TS User Manual page 86

Super X11DSN-TS User's Manual
 Serial Port 2 Configuration
Serial Port 2
Select Enabled to enable Serial Port 2. The options are Enabled and Disabled.
Device Settings (Available when the item above "Serial Port (2)" is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of a serial
port specified by the user.
Change Settings
This feature specifies the base I/O port address and the Interrupt Request address of Serial
Port 2. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to a
serial port specified.
The options for Serial Port 2 are Auto, (IO=2F8h; IRQ=3), (IO=3F8h; IRQ=3), (IO=3E8h;
IRQ=3) and (IO=2E8h; IRQ=4).
Serial Port 2 Attribute
Select SOL to use COM Port 2 as a Serial_Over_LAN (SOL) port for console redirection.
The options are COM and SOL.
Serial Port Console Redirection

COM 1
Console Redirection
Select Enabled to enable COM Port 1 for Console Redirection, which will allow a client
machine to be connected to a host machine at a remote site for networking. The options are
Enabled and Disabled.
*If the item above set to Enabled, the following items will become available for configuration:
Console Redirection Settings (for

Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII Character set. Select VT100+ to add color and function
key support. Select ANSI to use the Extended ASCII Character Set. Select VT-UTF8 to
use UTF8 encoding to map Unicode characters into one or more bytes. The options are
VT100, VT100+, VT-UTF8 and ANSI
COM 1)
86