Wired Remote Controller Test Run Settings - Sanyo CHDZ07263 Service Manual

3. Timer Remote Controller

3-14. Wired Remote Controller Test Run Settings

1. Press the remote controller
2. "TEST" appears on the LCD display while the test run is in progress.
3. Then press the
●
The temperature cannot be adjusted when in Test Run mode.
(This mode places a heavy load on the machines. Therefore use it only when performing the test run.)
●
The test run can be performed using the HEAT, COOL, or FAN operation modes.
NOTE
The outdoor units will not operate for approximately 3 minutes after the power is turned ON and after operation is stopped.
●
If correct operation is not possible, an error code is displayed on the remote controller LCD display.
(Refer to "Table of Self-Diagnostic Functions" and correct the problem.)
4. After the test run is completed, press the
●
To prevent continuous test runs, this remote controller includes a timer function that cancels the test run after 60 minutes.
●
The operation is possible even if the cassette-type ceiling panel has not been installed. ("P09" display does not occur.)
1
2
3
4
5
6
7
button for 4 seconds or longer.
button.
button again. Check that "TEST" disappears from the LCD display.
2 - 30
Remote Control Functions