Sleep Mode; Hibernation Mode - Lenovo ThinkPad X1 Carbon Hardware Maintenance Manual

To put the computer into screen blank mode, do the following:
1. Right-click the battery gauge in the task bar.
2. Select Power off display.
To end screen blank mode and resume normal operation, press any key.

Sleep mode

When the computer enters sleep mode, the following events occur in addition to what occurs in screen
blank mode:
• The LCD is powered off.
• The solid-state drive is powered off.
• The microprocessor stops.
To enter sleep mode, press Fn+4 or do the following:
• For Windows 7: Use the Start menu shutdown option.
• For Windows 8.1: Move the pointer to the bottom right corner of the screen to bring up the charms.
Then click Settings ➙ Power ➙ Sleep.
In certain circumstances, the computer goes into sleep mode automatically:
• After a period of inactivity specified in power plan settings
• When the battery indicator blinks orange, indicating that the battery power is low
To resume the computer from sleep mode, press the power button.
Also, in either of the following events, the computer automatically returns from sleep mode and resumes
operation:
• The ring indicator (RI) is signaled by a serial device or a PC Card device.
• The time set on the resume timer elapses.
Note: The computer does not accept any input immediately after it enters sleep mode. Wait a few
seconds before taking any action to reenter operation mode.

Hibernation mode

In hibernation mode, the following occurs:
• The system status, RAM, VRAM, and setup data are stored on the hard disk.
• The system is powered off.
Note: If the computer enters the hibernation mode while it is docked to the docking station, do not undock it
before resuming normal operation. If you do undock it and then try to resume normal operation, you will get
an error message, and you will have to restart the system.
If you have defined one of the following actions as the event that causes the system to go into hibernation
mode, perform that action.
• Closing the lid.
• Pressing the power button.
Also, the computer goes into hibernation mode automatically after a period of inactivity specified in power
plan settings.
.
Chapter 4 Related service information
35