Supervisor Password; How To Remove The Power-On Password - Lenovo ThinkPad X1 Carbon Hardware Maintenance Manual

• User hard disk password - for the user
• Master hard disk password - for the system administrator, who can use it to get access to the hard disk
even if the user has changed the user hard disk password
Note: There are two modes for the hard disk password: User only and Master + User. The Master + User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If it has, it can be used for access to the hard disk drive. If no master hard disk password is
available, neither Lenovo nor Lenovo authorized service technicians provide any services to reset either
the user or the master hard disk password, or to recover data from the hard disk drive. The hard disk drive
can be replaced for a scheduled fee.
For how to remove the hard disk password, see "How to remove the hard disk password" on page 34.

Supervisor password

A supervisor password protects the system information stored in the ThinkPad Setup. The user must enter
the supervisor password in order to get access to the ThinkPad Setup and change the system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for
a scheduled fee.

How to remove the power-on password

To remove a power-on password, do the following:
If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer and disconnect ac power.
2. Disable the built-in battery. See "Disabling the built-in battery" on page 54.
3. Remove the base cover assembly. See "1010 Base cover assembly" on page 55.
4. Locate the coin-cell-battery reset button
Then wait for a few seconds.
5. Reinstall the base cover assembly.
6. Reconnect ac power.
1
. Press the reset button to disable the coin-cell battery.
1
.
Chapter 4 Related service information
33