Table of Contents
Advertisement
8. SETTINGS
8.1 Introduction
When pressing a key
combination, do not tilt your
fingers downwards . The
sensors of the underneath
buttons are sensitive and
may interfere with Your
choice.
8.2 Acoustic signals
This appliance is provided with different
acoustic signals, that operate when:
• You activate the appliance (special
short tune).
• You deactivate the appliance (special
short tune).
• You touch the buttons (click sound).
• You make a wrong selection (3 short
sounds).
• The programme is completed
(sequence of sounds for about 2
minutes).
• The appliance has a malfunction
(sequence of short sounds for about 5
minutes).
• When a laundry overload is detected
during ProSense phase (a double
sound played one).
To activate/deactivate this option, hold
down the Extra máchání button until a
beep or a double beep sounds.
If you deactivate this
function, the acoustic signals
stops playing at the end of
the programme only.
8.3 Child Lock
With this option you can prevent children
from playing with the control panel.
To activate/deactivate this option, hold
down the Skvrny/Předpírka button until
comes on/goes off on the display.
The appliance will default to this option
after you switch it off.
8.4 Operating Hours Counter
It is possible to visualise the total
operating time of the appliance in hours,
starting from the first switching on. This
value will count operating time of the
cycles (does not include pauses, delayed
start time). To visualise this value,
proceed as follows:
1. Switch the appliance on by pressing
the Zap./Vyp. button.
2. Press and hold the Extra máchání
and Pára plus buttons for some
seconds.
3. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
4. To exit this mode, press any button
or switch the appliance off by means
of theZap./Vyp. button.
If the procedure does not
work (due to timeout or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
8.5 Factory Defaults
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by pressing
Zap./Vyp. button.
2. Press and hold the Skvrny/Předpírka
and Úspora času buttons for some
seconds.
3. The display will show
about 5 seconds.
ENGLISH
21
for
Advertisement
Table of Contents
