Table of Contents
Advertisement
General features
Audio Control
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item
Display
Bass Center Frequency "Bass FRQ"
Bass level
"Bass"
Bass Q Factor
"Bass Q"
Bass Extend
"Bass EXT"
Middle Center
"MID FRQ"
Frequency
Middle level
"MID"
Middle Q Factor
"Middle Q"
Treble Center
"TRE FRQ"
Frequency
Treble level
"TRE"
Balance
"Balance"
Fader
"Fader"
Volume offset
"Volume Offset" –8 — ±0
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
1.00/1.25/1.50
2.00
Range
60/70/80/100 or 150 Hz
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 kHz
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
Bass Center Frequency
60/70/80/100
60/70/80/150
• When the Bass Extend is set to ON, low frequency response is
extended by 20%.
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
5
Exit Audio Control mode
Press the [AUD] button.
Speaker Setting
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2
Enter Speaker Setting mode
Press the [Q] button.
"Speaker Setting" is displayed.
3
Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
4
Exit Speaker Setting mode
Press the [Q] button.
— 8 —
Display
"OFF"
"5/4 inch"
"6
9/6 inch"
*
"O.E.M."
Advertisement
Table of Contents
