Setup Mode Programming; Intro Operation Customer Warranty - Cobra MARINE MRHH150FLTE Owner's Manual

Setup Mode Programming

Intro Operation Customer Warranty
VHF Marine Radio Protocols Operating Your Radio VHF Marine Radio Protocols
Assistance
Intro Operation Customer
Assistance
Setup Mode Programming
The following series of procedures is designed to allow you to set the programmable
Customer
Installation
Assistance
features of your radio. Correctly following these steps results in a minimal amount of
econdary Icons
Customer
radio setup programming time.
Installation
Assistance
NOTE
Secondary Icons
When in the Setup mode, if you stop programming for longer than 10
ain Icons
Notice Caution Warning
seconds, your entry will be saved and the radio will go back to the Marine
Standby mode. Pressing any of the non-programming buttons (Talk, Dual-
Watch/Scan, H-M-L, Instant Channel 16+) will also exit Setup mode and
Notice Caution
invoke the button function or return the radio to Marine Standby mode.
Intro Operation Customer Warranty
When you return to Setup mode and continue programming you will see the last
Assistance
"value" displayed. While in the Setup mode, you will not receive any signal reception.
Customer
Installation
Assistance
econdary Icons
Marine (VHF) Mode Programming
Programming these features will allow you to customize certain features of this radio Notice Caution Warning
to enhance your "On-Water" audio needs.
MARINE HH150
Start from Marine Standby mode to begin Marine (VHF) Setup
Enter/Setup Button
programming. Press and hold the Enter/Setup button for three
SETUP
seconds to enter the programming mode.
H-M-L ENTER
ANNEL
16+
VOL +
ERSIBLE
14 English
Warranty
Warning
FLOATING MARINE HH150
ESC
PWR
MEM
SC/DW
VOL
SUBMERSIBLE
VHF Marine Radio Protocols VHF Marine Radio Protocols Operating Your Radio
Intro Operation
International/Canada/U.S.A. Channel Maps
•
Three sets of VHF Channel Maps have been established for marine use in the U.S.A.,
Canada, and the rest of the world (International). Most of the channels are the same
for all three maps, but there are definite differences (see table in the Appendix).
Installation
Your radio has all three maps built into it and will operate correctly in whichever
area you choose.
Secondary Icons
Main Icons
Set Channel Map
Active Channel Map Icon
FLOATING MARINE HH150
WEATHER SETUP
Secondary Icons
ESC
H-M-L
PWR MEM
Channel Up/Down Buttons
H-M-L
ENTER
CHANNEL
SC/DW
CHANNEL
VOL
+16
SUBMERSIBLE
Roger Beep Mode
VOL
Setup Mode Programming
Customer Warranty
Assistance
Customer
Assistance
To Set Channel Map Operating Area:
1. The Channel Map mode is the first mode that begins the
Marine (VHF) Setup programming.
Notice Caution Warning
2. U, I and C will display, with the current setting
Intro Operation Customer Warranty
(the U icon is the default) flashing.
Assistance
3. Press Channel Up/Down buttons to select the
U, I or C icon.
Customer
Installation
4. Press Enter/Setup button to save this entry and move to the
Assistance
next setup programming mode.
SETUP
NOTE
ENTER
One or two of the channel maps might have been
Notice Caution Warning
disabled for sales of this radio in some countries.
16+
VOL +
Roger Beep Mode
In Roger Beep mode, your listener will hear an audible tone
when you release the Talk button. This alerts your listener
that you are finished talking and it is OK for them to speak.
To Set Roger Beep On or Off:
1. Press and hold the Setup button for 3 seconds.
2. Press Channel Up/Down buttons to select ON or OFF. ROG
will be displayed when On.
3. Press Enter/Setup button to save this entry and move to the
next setup programming mode – Key Tone.
Nothing Comes Close to a Cobra
® 15