Setup Mode Programming; Intro Operation Customer Warranty - Cobra Marine MR HH125 Owner's Manual

Setup Mode Programming

Intro Operation Customer Warranty
Assistance
Operating Your Radio VHF Marine Radio Protocols VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Setup Mode Programming
Customer
Installation
The following series of procedures is designed to allow you to set the programmable
Assistance
features of your radio. Correctly following these steps results in a minimal amount
dary Icons
of radio setup programming time.
Customer
Installation
Assistance
cons
NOTE
Secondary Icons
When in the Setup mode, if you stop programming for longer than 15 seconds,
Notice Caution Warning
your entry will be saved and the radio will go back to the Marine Standby
mode. Pressing any of the non-programming buttons (Talk, Dual-Watch/Scan,
Intro Operation Customer Warranty
Power Level/Weather, Instant Channel 16/9) will also exit Setup mode and
Notice Caution
Assistance
invoke the button function or return the radio to Marine Standby mode.
When you return to Setup mode and continue programming you will see the last
Customer
"value" displayed. While in the Setup mode, you will not receive any signal reception.
Installation
Assistance
dary Icons
Marine (VHF) Mode Programming
Programming these features will allow you to customize certain features of this
Notice Caution Warning
radio to enhance your "On-Water" audio needs.
Start from Marine Standby mode to begin Marine (VHF)
Enter/Setup Button
Setup programming. Press and hold the Enter/Setup button
for three (3) seconds to enter the programming mode.
14 English
Warranty
Warning
VHF Marine Radio Protocols VHF Marine Radio Protocols Operating Your Radio
Intro Operation
U.S.A./International/Canada Channel Maps
•
Three (3) sets of VHF Channel Maps have been established for marine use in the U.S.A.,
Canada, and the rest of the world (International). Most of the channels are the same
for all three (3) maps, but there are definite differences (see table in the Appendix).
Installation
Your radio has all three (3) maps built into it and will operate correctly in whichever
area you choose.
Secondary Icons Main Icons
Set Channel Map
Active Channel Map Icon Secondary Icons
Channel Up/Down Buttons
Setup Mode Programming
Customer Warranty
Assistance
Customer
Assistance
To Set Channel Map Operating Area:
1. The Channel Map mode is the first mode that begins the
Marine (VHF) Setup programming.
Notice Caution Warning
2. U, I and C will display, with the current setting
Intro Operation Customer Warranty
Assistance
(the U icon is the default) flashing.
3. Press Channel Up/Down buttons to select the
U, I or C icon.
Customer
Installation
Assistance
4. Press Enter/Setup button to save this entry and move to
the next setup programming mode – Roger Beep.
NOTE
One or two of the channel maps might have been disabled
Notice Caution Warning
for sales of this radio in some countries.
Nothing Comes Close to a Cobra
15
®