Bosch CMG978N 1A Series User Manual And Installation Instructions page 16

en Time-setting options
Set a suitable type of heating and a temperature of
1.
at least 100 °C.
Rapid heating automatically switches off at temper-
atures of 200 °C and above.
2. Press "Rapid heating".
a The symbol lights up red.
Press to start the operation.
3.
10 Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting Use
option
Cooking time If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
10.1 Setting the cooking time
You can set the cooking time for the operation up to
24 hours.
Requirement: An operating mode and temperature or
level have been set.
Press ⁠ "Cooking time".
1.
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "m".
a The selected value is marked in blue.
Use the setting ring to set the cooking time.
3.
If required, use to reset the setting value.
Press to start the operation.
4.
a The appliance starts to heat and the time counts
down.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
5.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the cooking time
You can change the cooking time at any time.
Press the cooking time
1.
Use the setting ring to change the cooking time.
2.
a The change is applied.
Cancelling the cooking time
You can cancel the cooking time at any time.
16
to switch the ap-
⁠ .
a Rapid heating starts.
a Once rapid heating has ended, a signal sounds.
The symbol changes back to white.
Place the food in the cooking compartment.
4.
Cancelling rapid heating
Press "Rapid heating".
▶
a The symbol changes back to white.
Press the cooking time
1.
Reset the cooking time using
2.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
a The change is applied.
10.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Notes
¡ To achieve good cooking results, do not delay the
time once the operation has already started.
¡ Food will spoil if you leave it in the cooking com-
partment for too long.
Requirements
¡ An operating mode and temperature or level have
been set.
¡ A cooking time is set.
Press ⁠ "End time".
1.
To set the time, press the hour display or the minute
2.
display.
a The selected value is marked in blue.
Use the setting ring to delay the time.
3.
If required, use to reset the setting value.
Press to start the operation.
4.
a The display shows the time remaining until the oper-
ation starts. The appliance is in standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
a When the time has elapsed, a signal sounds. A noti-
fication appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
5.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press the end time
1.
Use the setting ring to change the end time.
2.
a The change is applied.
Cancelling the end time
You can delete the set end time at any time.
Press the end time
1.
⁠ .
⁠ .
to switch the ap-
⁠ .
⁠ .