Permissible Accessories; Storage And Handling Of The Recommended Accessory Tools; Working Procedures - Parkside 392682 2201 Translation Of The Original Instructions

Permissible accessories

Cutting disc
Roughing disc
Storage and handling of the
recommended accessory tools
■ Grinding tools must be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical dam-
age or environmental influences (e.g. damp).

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■ Move the angle grinder with moderate
pressure back and forth over the workpiece.
■ For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
PWS 125 F6
125 3 M14
125 6 M14
Two-hole assembly
12200 80
Two-hole assembly
12200 80
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting
or grinding discs that are approved for a
peripheral speed of not less than 80 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece.Use clamps/vices to
hold the workpiece firmly. This is much safer
than simply holding it in your hand.
■ Always switch off the appliance before put-
ting it away and wait for the appliance to
come to a complete standstill.
■ Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out. Move it into the OFF position.
This prevents an uncontrolled restart.
■ Use the appliance only for dry cutting or
sanding.
Yes
spanner
No
spanner
GB │ MT │ 57 ■