Registration - VTech VT5881 Manual

Registration

Registering an i 5801 Handset for the first time
After charging, the screen will display:
Find the BASE ID Code by doing the following (Base must
be OFF):
1) At the Base, press MENU.
2) Scroll down to DISPLAY BASE-ID, then press OK.
3) Enter the 15-digit Base ID Code into the Handset. If you make a
mistake, move the joystick to the left (
to backspace and erase a character.
4) Press OK to complete the registration process.
NOTE: If the Handset, after charging, says "Searching for Base...", press the
NEW soft key. "Enter Base ID" will now be displayed. Follow the steps above.
Wait approximately 15-60 seconds. You will hear confirmation beeps from the
Base and Handset. The newly registered Handset will now be assigned the
lowest extension number not previously assigned to a different system Handset
(1 - 6).
If you do not enter the correct digit sequence, you will see " Invalid Base ID!" and
hear an error tone. Move the joystick to the left (
softkey to backspace, and carefully re-enter the Base ID Code.
NOTE: The 15-digit BASE ID Code may contain numbers and characters,
such as *. Make sure you carefully enter all 15 digits.
) or press
) or press
8
softkey