Inserting The Batteries In The Remote Control; Handling The Remote Control - Dell P5524Q User Manual

Hide thumbs Also See for P5524Q:

Table of Contents

Inserting the batteries in the remote control

The remote control is powered by two 1.5 V AAA batteries.

To install or replace batteries:

1. Press and then slide the cover to open it.

2. Align the batteries according to the (+) and (–) indications inside the battery

compartment.

3. Replace the cover.

CAUTION: The incorrect use of batteries can result in leaks or

bursting. Be sure to follow these instructions:

• Place "AAA" batteries matching the (+) and (–) signs on each battery to the

(+) and (–) signs of the battery compartment.

• Do not mix battery types.

• Do not combine new batteries with used ones. It causes shorter life or

leakage of batteries.

• Remove the dead batteries immediately to prevent them from liquid leaking

in the battery compartment. Do not touch exposed battery acid, as it can

damage your skin.

NOTE: If you do not intend to use the remote control for a long period,

remove the batteries.

• Do not subject to strong shock.

• Do not allow water or other liquid to splash the remote control. If the remote

control gets wet, wipe it dry immediately.

• Avoid exposure to heat and steam.

• Other than to install the batteries, do not open the remote control.

Setting up the monitor

Table of Contents