Table of Contents
Advertisement
flashes, lights up at the same time
›
Check the engine oil level.
The oil level is OK, the warning light continues to
flash:
›
Stop the engine and seek the help of a specialist
garage.
Engine oil level too low
illuminates together with
or
illuminates together with
Message regarding required engine oil top up
›
Check the engine oil level, top up with oil if re-
quired.
Engine oil level too high
illuminates together with
or
illuminates together with
Message regarding the need to reduce the
engine oil level
›
Check the engine oil level.
The oil level is too high:
›
Drive on, exercising appropriate caution.
›
Seek the help of a specialist garage.
Engine oil level sensor impaired
illuminates together with
or
illuminates together with
Message regarding the engine oil sensor
›
Drive on, exercising appropriate caution.
›
Seek the help of a specialist garage.
Coolant
Coolant temperature gauge
Cold area
A
Engine, exhaust system and fuel ›
›
Avoid high engine speed.
Operating range
B
High temperature range
C
Checking the fill level and topping up
Test conditions
✓ The vehicle is on a horizontal surface.
✓ The engine is turned off and cooled.
Checking the level
NOTICE
Danger of damage to the engine compartment!
Do not top up the coolant above the marked area.
▶
The coolant could be forced out of the cooling sys-
tem when heated.
NOTICE
There must be a small quantity of coolant in the tank.
Do not add coolant when the tank is empty.
▶
Stop driving! Seek the help of a specialist garage.
▶
Refilling
CAUTION
Risk of scalding!
The cooling system is pressurised.
Do not open the cap of the coolant expansion tank
▶
while the engine is warm. Let the engine cool
down.
›
Place a rag on the lid of the tank and carefully un-
screw the lid.
›
Refill with coolant of the correct specification.
›
Screw on the cap until it clicks into place.
Specification
Use the G12evo (TL 774 L) additive for refilling.
NOTICE
Risk of damage to the cooling system and the en-
gine!
Adding coolant that does not conform to the correct
specification can reduce the corrosion protection of
the cooling system.
Coolant
193
The fill level must be
within the marked range.
›
If the fill level is below
the mark
, top up
the coolant.
Advertisement
Table of Contents
