Troubleshooting - Bushnell PRIME LP520KB Manual

TROUBLE SHOOTING
Never disassemble your laser rangefinder. Irreparable damage can result from unauthorized service attempts, which also void
the warranty.
If unit does not turn on, display does not illuminate:
• Depress power button.
• Check and if necessary, replace battery. If unit does not respond to key presses, replace the battery with a good
quality CR2 3-volt Lithium battery.
• Ensure the display is on the brightest setting while in sunlight. While pressing Power Button, cover the objective lenses to
determine if the display is on.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality 3 -volt lithium battery (CR2).
If target range cannot be obtained:
• Make sure Display is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit
and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
NOTE: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using
the display reticle, depress the power button and hold until new range reading is displayed. Specifications, instructions, and the
operation of these products are subject to change without notice.
Technical Specifications
LP520KB 5x 20mm
LP623SBL 6x 24mm
1300/1189 500/457 400/366
800/732 480/439 240/219
+/- 0.5 yds Fully-multi coated,
EXO Barrier™
+/- 0.5 yds Fully-multi coated,
EXO Barrier™
4.2/106 5.8/165
4.1/103 5.8/165
5