Introduction To Web Configuration; Preparation Before Login - D-Link DSL-2600U User Manual

Web Configuration
The first time you setup the Router. It is recommended that you configure the WAN connection using a single computer, to ensure that both the computer and the Router are
not connected to the LAN. Once the WAN connection operates properly, you may continue to make changes to Router configuration, including IP settings and DHCP setup.
This chapter is concerned with using your computer to configure the WAN connection. The following chapter describes the various menus used to configure and monitor the
Router, including how to change IP settings and DHCP server setup.
Before accessing the Modem, ensure the communication between PC and Modem is normal. Check the communication as follows.
=
Configure the IP address of the PC as 10.1.1.X (2~254), net mask as
255.0.0.0, gateway address as 10.1.1.1 (for customized version, configure
them according to the actual version).
=
Enter arp -a in the DOS window to check whether the PC can read the MAC
address of the Modem.
=
Ping the management IP address (10.1.1.1 by default) of the Modem.
If the PC can read the MAC address of the Modem and can ping through the
management IP address of the Modem, that means the communication of
the PC and the Modem is normal.
D-Link DSL-2600U User Manual

Introduction to Web Configuration

Preparation Before Login

11