Stanton S-700 User Manual page 6

direction the faster you search through the music.
b.Playback (Effect control) - Turn 1/3 of the way left
for reverse play. Turn 1/3 of the way right to go back
to normal forward play. Turn all the way left for motor
off effect all the way rich for brake effect. Release the
wheel to go back to normal play.
13. JOG WHEEL (INNER RING) - This jog wheel has 2
functions depending on the mode you are working in.
a. The jog wheel will act as a slow frame search
control when the CD is not playing but either
paused or set to a cue point. To set a new frame
cue point, spin the wheel then press PLAY when
you have determined the proper position. Press
CUE to return to the "CUE POINT".
b. The JOG wheel can temporarily bend the pitch of
the music up to +/-16% if the song is already
playing by rotating the wheel clockwise to speed
up or counterclockwise to slow down. The amount
of pitch change is determined by the speed of
rotation.
14. CUE - Pressing the CUE button during play provides
a return to the position at which play was started. If
pause is used before CUE or CUE point was set, that
will become the cue point. With the unit in the pause
mode (Play/Pause LED blinks) the search and/or jog
wheel is used to set a different start point. By
pressing "PLAY/PAUSE" button then "CUE", you can
confirm this new cue point is desirable. The CUE LED
will light up since the cue button is pressed until the
CD has returned to the position at which play was
started.
15. IN/R.CUE - This allows you to set the cue point
without stopping the play back. This button also sets
the beginning of a seamless loop.
16. OUT/EXIT - Used to set the ending when looping
music. The player will start to loop continuous until
you press this button again to exit.
17. RELOOP BUTTON - If a loop has been made and
you have hit the exit button, press this button to enter
the loop again. To exit loop pressing OUT/EXIT
button.
18. PITCH SLIDER - The pitch can be changed by
pressing the PITCH button so the PITCH LED is lit,
then moving the sliding fader.
The pitch will not be changed if the PITCH LED is off.
If you want to change the pitch adjustment range (+/-
8%, +/-12%, +/-16%), press and hold PITCH button
then press the PITCH BEND+ to select.
19. RELAY - Pressing the RELAY button to enable or
disable RELAY function.
While the Relay is enabled, the LED will be lit.
In the single mode, the CD player will be paused at
the next track when finish playing current track;
The other side of CD player that is in pause mode will
start playing automatically.
There is no Fader start function when in the Relay
mode.
Press the RELAY button to disable Relay function.
The LED will be off when Relay is disabled.
20. BPM BUTTON - Switches the mode of the display
between BPM and pitch.
21. CONTROL JACK - This is used to START or PAUSE
the unit via an external mixer with FADER start
control, such as the NEXT! BY STANTON PRO-30
22. PLAY/PAUSE - Each press of the PLAY/PAUSE
button causes the operation to change from play to
pause or from pause to play.
23. REMOTE JACK - Connect to the drawer unit to
enable CD control via the controller unit.
24. TRACK - (Track Search Buttons) - These buttons are
used to select the track to be played. Forward skip &
Back skip.
25. SEAMLESS CUE (SQ) - This button is used to go
back to the selected cue point without interuption in
playback.
5