Advertisement
Reference Value
Finished
Wall
305
400
INSTALLATION
TO REMOVE EXISTING TOILET
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
NOTICE:
if the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
NOTICE: Do not use white cement or high lime content
cements to install this toilet. The expansion of cement due to
a rise in temperature may make the toilet crack or cause
damage. Kohler is not responsible for any damage caused by
installation with the use of cement.
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it is
200mm above the finished floor line,
and 220mm to the left of the closet
flange centerline.
The centerline of the supply shut-off
valve outlet should extend 67mm from
the finished wall. Install the supply
shut-off valve with the outlet vertical.
1486239-T01-A
386
730
Supply
Reference
415.5
390
C
L
OF OUTLET
Kohler reserves the right to change marked dimensions without prior notice.
200
305/400
750
200
220
Fig.#1
1
Fig.#2
Closet Flange
Supply Shut-Off Valve
220
Closet Flange
Centerline
Fig.#3
3
-3-
FRONT OF BOWL
FRONT OF BOWL
287
For
S305
(
)
2
200mm
220
mm
Unit: mm
:
382
For
S400
T
67mm;
Advertisement
