Control Panel; On/Off Button (S0); Programme/Option Buttons (S1÷S6) - Electrolux DIVA 60 cm Service Manual

4 CONTROL PANEL

4.1 Control panel
The configuration of the control panel depends on the following:
Number of programme selection buttons (from a minimum of 3 to a maximum of 6)
Number of LEDs (max.9)
4.1.1

ON/OFF button (S0)

The ON/OFF button is featured on all models in the range, and is used to switch the appliance on and off.
Switching off does not cancel the programme being executed.
4.2 Programme/Option buttons (S1÷ ÷ ÷ ÷ S6)
The functions of the various buttons depend exclusively on the software configuration of each
appliance, which can feature from 3 to 6 buttons.
Also the selection of the washing programmes changes according to the configuration of each
appliance.
The buttons S1, S2, S3 are always featured because perform special functions.
MODELS WITH DIRECT SELECTION
To each button corresponds a specific programme:
1. Open the door and switch the appliance on [S0]
All programme LEDs light to indicate the selection
phase (except 3/1, if disabled)
2. Press a button to select a programme:
The relative LED remains on while the other
switch off.
The display shows the flashing time-to-end.
3. Set the possible option or the delayed start (if
available).
4. Close the door to start the cycle:
The digits light steady.
SOI/DT 2003 - 01 eb
MODELS WITH SEQUENTIAL SELECTION
In these versions one or two buttons are featured to
select the programmes:
1. Open the door and switch the appliance on [S0]
The display shows [ -- ]
2. Press button [+ ] to select with an increasing
order:
The LEDs relative to the programme buttons flash
(if featured)
The display shows the last selected flashing
programme. Every time the button is pressed the
following programme is selected (increasingly):
2 3.....
3. Press button [- ] to select with a decreasing order:
The LEDs relative to the programme buttons light (if
featured).
The display shows the last selected flashing
programme. Every time the button is pressed the
previous programme is selected:
4. Set the possible option or the delayed start (if
available).
5. Close the door to start the cycle:
The digits light steady.
6
1
7 6 5 .....
599 35 64-85